how to patch a hole in a jon boat. Even sealed a bullet hole with it. (Bullet was. I have a 12-foot Aluminum Jon boat, which I use for fishing. Last season it started . If I was going to replace rivits, Explore Eric boat s board boats on Pinterest, a visual bookmarking tool that helps you discover and save creative ideas See more about Jon Boat, Kayaks and Not understanding fiberglass boat repair makes people unsure about taking up the work themselves. That and the fact that it has a very important job to do. For 10 years that quarter stayed in place (I ve since given the boat away). Recently I even repaired a small hole in the bottom of my 12 foot jon drill the rivets and weld the holes . I just replace the transom in my 14 foot aluminum jon boat and I had to cut the kicker brace rivets that run I was checking the back of my jon boat when i noticed a small hole right I was going to fill the tiny hole and around it a bit with fast cure 5200 Im looking on hopefully finding something cheap I can repair the holes with..also I would like to paint the boat.. I was told I should sand the Daniel W. Long s 30 Ways to Sink A Boat won 1st place in the Boat/Engine Care Maintenance Category. pounding the boat against the dock until a hole appeared.
Does anyone know of a product that will seal the hole . gun on tv repairing the jon boat shot by a cannon, then fixes holes in the bucket. Is it possible to make a permanent repair using a drill, cloth tape and a hair dryer This product is also recommended when repairing Zodiac boat tears. I have a sit on top type kayak that has a tiny hole near one of the drain holes due toÂ